iGET SECURITIES M3P6

Accessories for security system iGET SECURITY M3 and M4 - M3P6 Wireless gas detector.

24.00 €

iGET SECURITY M3P6 - Wireless gas detectorIt is a wireless gas detector that can work independently or as an accessory for iGET SECURITY M3 and M4 alarms. Depending on the location, natural gas (LNG, CNG), propane butane (LPG) and petroleum substances can be detected.The M3P6 wireless gas detector is an accessory for the iGET SECURITY M3 and M4 alarms. It is used to detect natural gas (LNG, CNG), propane butane (LPG) and petroleum substances. It also includes fault detection, a test button and is powered from 230 V. The detector has a modern design and is environmentally friendly thanks to its low power consumption.The gas detector is already an integral part of houses, cottages, apartments, garages, etc., and is used in many ways:
- gas cooker in the kitchen,
- for gas boilers to detect gas leaks,
- in the garage for a car with LPG, LNG, CNG.Main parameters:- the detector is designed for all rooms where gas level monitoring is necessary,
- once the gas is detected, the warning LED will flash red and the detector siren will sound,
- the detector can also be wirelessly connected to the iGET SECURITY M3 and M4 alarms to provide comprehensive protection. Upon receiving an alarm signal, the alarm will sound a siren and send an SMS to inform you of this fact,
- the detector operates at a frequency of 433.29 MHz, thanks to which it can be used with many other brands of alarms that operate at the same frequency,
- simple extension of the basic set of iGET SECURITY M3 and M4 alarms,
- includes a test button to check functionality,
- detecting an error condition, the yellow LED will light up,
- processing in modern design, environmentally friendly thanks to low power consumption.Possible location and use of the detector:
Gases, which are lighter than air, rise - the detector placed to the ceiling:
Place the detector 0.3 to 1 m below the ceiling, and 60 cm from the corners, i.e. from where the two walls converge. It must be at least 1.5 m from the gas source to prevent false alarms.
This is natural gas (LNG, CNG).Gases that are heavier than air sink to the ground - place the detector to the ground:
Place the detector at a height of 0.3 to 1 m above the ground, and 60 cm from the corners, i.e. from where the two walls converge. It must be at least 1.5 m from the gas source to prevent false alarms.
These are propane butane (LPG) and petroleum substances.Specifications:
Broadcast frequency: 433,29 MHz
Operating temperature: -25°C ~ +50°C
Operating humidity: 10%~95% (non-condensing)
Environment: dry, indoor
Supply voltage: 230V, 50~60 Hz
Consumption : 2 ~ 3 W
Siren: 75 dB/m
Reaction: about 60 seconds
Sensitivity:
Natural gas: 6% LEL
Error rate: +-3%LEL
(LEL = lower explosive limit)
Signal range to the central unit: up to 100 m. in line-of-sight